Each PRT62MF series reader can be used as a universal identification point connected to the access controller or configured for autonomous work, as a simple access controller for a single door.
In the first case, the reader’s functionality is limited only to reading an identifier (card/PIN) and sending data to an external controller, which takes further action. In case of work in a standalone mode, PRT62MF terminals can independently supervise a single door using data entered in the process of their configuration.
NOTICE! Functionality of PRT readers has been upgraded.
General features
power supply 12 VDC
13.56 MHz MIFARE cards
reads CSN number
reads MSN and SSN number (refers only to MIFARE Classic cards)
programmable data output format
formats: Wiegand 26-66bit, Magstripe (Clock and data), RS232, RACS (Roger) and others
various ways of PIN and keypad codes transmission
LED and Buzzer controlled through separate inputs
outdoor/indoor installation
MIFARE card programming (when operate under RARC freeware software)
may operate as an offline standalone access controller
up to 120 indexed users with card and/or PIN (standalone mode)
authentication: Card and/or PIN
event log for 1024 transactions
built-in 1.5 A/30 V relay output (PRT64MF & PRT66MF readers only)
two NO/NC inputs
two 150 mA transistor outputs
operation with XM-2 I/O extension module
possible connection of the external PRT series reader (two way door control)
programmed manually or from PC
free managing software (RARC)
tamper
PRT62MF Features
average current consumption 65 mA
reading distance up to 6 cm
dimensions: 100.0 x 40.0 x 25.0 mm (height x width x thickness)
weight: ≈100.0 g
CE mark
environmental conditions of operation:
temperature from -25°C to +60°C
humidity from 10% to 95%
| Properties | |
|---|---|
| Reader type | Card |
| Standalone | Yes |
| With keyboard | Without keyboard |
| Working frequency | MIFARE (13.56MHz) |
Darbo valandos:
I-V 8:00 - 17:00
